Operations 17
2. Push the front end of the baffle inside the chassis.
3. Install the access panel (on page 15).
4. Lock the tower bezel.
5. Power up the server (on page 13).
Remove the air baffle
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
1. Power down the server (on page 13).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the tower bezel (on page 14).
4. Remove the access panel (on page 15).
To Next Page
Loading...
