HP ProLiant ML10 v2

Hardware options installation 30
11. Close the expansion slot cover retainer.
12. Install the air baffle (on page 16).
13. Install the access panel (on page 15).
14. Return the server to an upright position.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server (on page 13).
Optical drive option
To install the component:
1. Power down the server (on page 13).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do the following:
a. Unlock the tower bezel (on page 14).
b. Remove the tower bezel (on page 14).
4. Remove the access panel (on page 15).