Hardware options installation 35
3.
Remove the access panel ("Access panel" on page 6).
4. Access the removable media cage.
5. Remove the bezel blank.
NOTE: HP recommends that you remove all bezel blanks to facilitate drive installation.
6. Depending on the server, obtain the screws from one of the following locations:
o Bezel blank
o Chassis
o Accessory kit
7. Install the screws on the media device:
o For the HP ProLiant ML110 Generation 5 Server, install the screws in the top screw holes.
o For all other servers, install the screws in the bottom screw holes.
To Next Page
Loading...
