HP ProLiant ML110 - G2 Server User Manual

Hardware options installation 14
8.
Press down firmly until the processor installation tool clicks and separates from the processor, and
then remove the processor installation tool.
9. Close the processor socket retaining bracket and the processor retaining latch.
10. Install the heatsink. See the server installation sheet.
11. Install the access panel.
Installing a processor in HP ProLiant ML110 (G2, G3, and G4)
and ProLiant ML150 Generation 2 Servers
CAUTION: To prevent possible server malfunction and damage to the equipment, do not mix
single- and dual-core processors or processors with different speeds or cache sizes.
1. Power down the server (on page 6).
2. Extend the server from the rack, if applicable.

HP ProLiant ML110 - G2 Server Specifications

General

Server Type	Tower
Chipset	Intel E7210
Memory Type	DDR SDRAM
Maximum Memory	4 GB
Optical Drive	Optional
Processor Sockets	1
Memory Slots	4
Form Factor	Tower
Processor	Intel Pentium 4
Storage Controller	Integrated SATA
Drive Bays	2 x 3.5" internal
Network Controller	Integrated Broadcom Gigabit Ethernet
Power Supply	300W
Operating System Support	Microsoft Windows Server 2003, Red Hat Linux