HP ProLiant ML150

Memory
One of the following
depending on Model
Type DDR3 Registered (RDIMM) or Unbuffered (UDIMM)
DIMM Slots Total 12 DIMM slots
Standard
(Entry/Base Models)
2 GB
Standard
(Performance Models)
4 GB
Maximum (RDIMM) 48 GB (12 x 4 GB) for Registered Memory configurations
Maximum (UDIMM) 48 GB (12 x 4 GB) for Unbuffered Memory configurations
NOTE: Depending on the memory configuration and processor model the memory speed may run at
1066MHz or 800MHz. See the Online Memory Configuration Tool for details:
http://www.hp.com/go/ddr3memory-configurator .
Network Controller Embedded HP NC107i PCI Express Gigabit Server Adapter
Expansion Slots # Technology Bus Width** Connector
Width
Bus Number * Form Factor Notes
1 32-bit/33MHz
PCI
N/A N/A 1 Full length, full
height slot
Non Hot-plug
2 PCI-Express
(Gen 1)
x4 x8 2 Full length, full
height slot
Non Hot-plug
3 PCI-Express
(Gen 2)
x4 x8 7 Full length, full
height slot
Non Hot-plug
4 PCI-Express
(Gen 2)
x16 x16 5 Full length, full
height slot
Non Hot-plug
5 PC-Express
(Gen 2)
x4 x8 6 Full length, full
height slot
Non Hot-plug
* Default bus assignment (in decimal). Inserting cards with PCI bridges may alter the actual bus assignment number.
** Indicates the number of physical electrical lanes running to a PCI-e connector.
Storage Controller
One of the following
depending on Model
Entry Model HP Smart Array B110i SATA RAID Controller (RAID 0,1,10)
NOTE: To enable RAID for HP Smart Array B110i SATA controller, use EZ set-up
CD to download driver, hpahcisr.sys, part of EZ Set-up CD
For more information go to: www.hp.com/go/sataraid .
NOTE: SA B110i SATA RAID Controller ships standard with every server.
NOTE: HP Smart Array B110i does not support greater than 2TB hard drive.
Base Model HP Smart Array P410/Zero Memory RAID Controller (RAID 0,1std)
Performance Model HP Smart Array P410/256MB RAID Controller (RAID 0/1/1+0/5/5+0)
QuickSpecs
HP ProLiant ML150 Generation 6 (G6)
Standard Features
DA - 13249 North America — Version 33 — September 24, 2012 Page 3