HP ProLiant ML150 Quickspecs

System Unit Dimensions (WxHxD) 7.87 x 16.81 x 24.13 in (200 x 427 x 613 mm) (W/O foot stand)
Weight (approximate) Maximum:
(All hard drives, power
supplies and processors
installed)
30 kg
Minimum:
(One hard drive, power
supply and processor
installed)
16kg
Input Requirements
(per power supply)
Range Input Voltage 90 to 135 VAC
180 to 265 VAC
Normal Line Voltage 100 to 127 VAC
200 to 240 VAC
Rated Input Current load 10A at 100 to 127 VAC
5A at 200 to 240 VAC
Rated Input Frequency 47 to 66 Hz
Rated Input Power
(optional 750W RPS)
760 W Max
(940W) Max
BTU Rating Maximum
(optional 750W RPS)
1814 BTU
(2243) BTU
Power Specifications To review typical power ratings use the Power Advisor which is available via
the online tool located at URL: www.hp.com/go/proliant-energy-efficient
Power Supply Output
Power
(per power supply)
Rated Steady-State Power 460W (750W) at 100 VAC for system
460W (750W) at 200 VAC
Maximum Peak Power 460W (750W) at 100 VAC
460W (750W) at 200 VAC
System Inlet
Temperature
Operating 50° to 95° F (10° to 35° C) at sea level with an
altitude derating of 1.8°F per 1,000 ft (1.0° C per
every 305 m) above sea level to a maximum of
10,000 ft (3050 m) no direct sustained sunlight .
Maximum rate of change is 18°F/hr (10°C/hr). The
upper limit may be limited by the type and
number of options installed. System performance
may be reduced if operating with a fan fault or
above 86°F (30°C).
Non-Operating -40° to 140° F (-30° to 60° C)
Relative Humidity
(non-condensing)
Operating 10% to 90% relative humidity (Rh), 82.4°F (28°C)
maximum wet bulb temperature, non-
condensing.
Non-operating ** 10% to 95% relative humidity (Rh), 101.7°F
(38.7°C) maximum wet bulb temperature, non-
condensing.
Altitude Operating 10,000 ft (3000m). Maximum allowable altitude
change rate is 1°C per 300m.
Non-Operating 30,000 ft (9144m). Maximum allowable altitude
change rate is 1°C per 300m.
QuickSpecs
HP ProLiant ML150 Generation 6 (G6)
Technical Specifications
DA - 13249 North America — Version 33 — September 24, 2012 Page 41

HP ProLiant ML150 Specifications

General

Tcase	72.8 °C
Bus type	QPI
Stepping	R2
FSB Parity	No
Scalability	2S
Processor cache	15 MB
Processor cores	6
Processor model	E5-2603V3
System bus rate	6.4 GT/s
Processor series	Intel Xeon E5-2600 v3
Processor socket	LGA 2011-v3
Processor codename	Haswell
Motherboard chipset	Intel C610
Number of QPI links	2
Processor frequency	1.6 GHz
Processor cache type	Smart Cache
Processor lithography	22 nm
Processor manufacturer	Intel
Processor package size	52.5 x 45 mm
Processor front side bus	- MHz
Processor operating modes	64-bit
ECC supported by processor	Yes
PCI Express configurations	x4, x8, x16
Supported instruction sets	AVX 2.0
Thermal Design Power (TDP)	85 W
Number of processors installed	1
Physical Address Extension (PAE)	46 bit
Maximum number of PCI Express lanes	40
Memory types supported by processor	DDR4-SDRAM
Memory channels supported by processor	Quad
Memory clock speeds supported by processor	1600 MHz
Memory bandwidth supported by processor (max)	51 GB/s
Maximum internal memory supported by processor	768 GB
HDD size	- \
RAID support	-
HDD interface	Serial ATA
Total storage capacity	0 GB
Maximum storage capacity	- TB
Number of HDDs installed	0
Memory slots	16x DIMM
Internal memory	4 GB
Memory clock speed	2133 MHz
Maximum internal memory	256 GB
Memory layout (slots x size)	1 x 4 GB
Graphics card family	NVIDIA
Intel® Virtualization Technology (Intel® VT)	VT-d, VT-x
Ethernet interface type	Gigabit Ethernet
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	4
Chassis type	Rack (1U)
Power supply	550 W
Processor ARK ID	83349
Intel Secure Key Technology version	1.00
Intel Identity Protection Technology version	0.00
PCI Express slots version	3.0

Weight and Dimensions

Depth	620 mm
Width	200 mm
Height	432.6 mm
Weight	22230 g