11. Starting near the bottom right (as viewed from the rear), pull the rear closure up to disengage it from
the computer. Work upward, and then toward the left, lifting the enclosure up to disengage, and then lift
the rear enclosure o the computer.
IMPORTANT: On models with a webcam, the webcam cable connects from the rear enclosure to the
system board.
TIP: Release all the catches around the edges of the cover rst, and then pull up on the center of the
cover to release the center catches.
12. Position the rear enclosure next to the computer. Note proper webcam cable routing, as pointing out in
the following image. The webcam cable routes across the display panel and then under the chassis. You
must remove the chassis from the panel to remove the webcam cable.
13. To remove the main chassis, remove the four Phillips screws around the sides (1) and the Phillips screw
in the middle (2) of the chassis.
Rear enclosure and display assembly 49
To Next Page
Loading...
