Core I/O Connections and Indicators
99
Although any terminal capable of operating in VT-100 mode can be used, the HP700 series terminal is used
here as an example because it is fairly common and it’s configuration is typical of many terminals currently in
use.
HP700 VT-100 Mode Configuration The following procedure outlines the steps to configure the HP700
series terminal for VT-100 operation.
NOTE You may use either the arrow keys or the tab key to move between the setting options on the
screen.
1. Press
[config keys] function key. [f8]
2. Press
[terminal config] function key. [f5]
3. Move to Terminal ID and enter “vt100”.
4. Move to Set TermMode and, using the [Prev] and [Next] keys, select “EM100”.
5. Press the [config keys] function key. [f8]
6. Press the [ansi config] function key. [f6]
7. Move to “multipage” and, using the [Prev] and [Next] keys, select “yes”.
(Enables screen scrolling).
8. Move to Backspace Del and, using the [Prev] and [Next] keys, select “Backspace/Del”.
9. Move to EM100 ID and, using the [Prev] and [Next] keys, select “EM100”.
To Next Page
Loading...
