Back-to-Back Test Cables
Two 5-meter, back-to-back, synchronous test cables are available from
HP. These cables allow you to connect any HP router having a (62-pin)
synchronous WAN port to another HP router (or an HP Remote Bridge)
having the same port type, without using a modem eliminator, for up to
60 meters (200 feet). These cables use the RS-422 signal level. Use the
test cables for demonstrations, instruction, or testing the router.
The two test cables available are:
Description
Connector at End
For Other Device Part Number
Back-to-back test cable,
5 meters
62-pin, male
(Most HP routers and the
HP Remote Bridge RB)
5061-2556
Back-to-back test cable
(high-speed balanced),
5 meters
15-pin, male
(HP 27270 Router CR)
5061-2557
The minimum pin-outs for the two cables are shown on the following
pages.
Cables and Connectors
Cable and Connector Pin-Outs
A-13
To Next Page
Loading...
