2. At the NCL prompt, enter one of the following commands:
• For LAN and WAN circuits:
get cct.cct-name.mac_addr [Return]
• For FDDI circuits (HP Router BR only):
get cct.fddi-name.ieee.addr [Return]
where: cct-name or fddi-name is the configured circuit
name for the port. Examples of circuit names are ETHER1,
WAN1, TOKEN1, and FDDI1.
3. Note the resulting station address.
4. Use the Exit command to leave NCL and return to the Main menu:
exit [Return]
Troubleshooting
Diagnostic Tests
3-17
To Next Page
Loading...
