Card reader board
Description Spare part number
Card reader board (includes cable) 828821-001
Before removing the card reader board, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 19).
5. Remove the battery (see Battery on page 21).
6. Remove the speakers (see Speakers on page 26).
Remove the card reader board:
1. Release the ZIF connector (1) to which the card reader board cable is attached, and then
disconnect the card reader board cable from the system board.
2. Remove the Phillips PM2.0×2.7 screws (2) that secure the card reader board to the top cover.
3. Remove the card reader board (3) and cable from the top cover.
4. Remove the card reader board.
Reverse this procedure to install the card reader board.
Card reader board 29
To Next Page
Loading...
