Power connector cable
Description Spare part number
Power connector cable 801513-001
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 19), and then remove the following components:
a. Remove the battery (see Battery on page 21).
b. Remove the fan (see Fan on page 25).
c. Remove the system board (see System board on page 30).
d. Remove the display assembly (see Display assembly on page 36).
Remove the power connector cable:
1. Release the power connector cable (1) from the retention clips built into the bottom cover.
2. Remove the Phillips PM2.0×4.1 screw (2) that secures the power connector to the top cover.
3. Remove the power connector cable (3).
Reverse this procedure to install the power connector cable.
Power connector cable 39
To Next Page
Loading...
