Installing an internal DAT tape drive14
Mounting rails
Some HP ProLiant servers, such as ML530 and ML570, require mounting rails. These may be metal
or plastic rails attached to the filler panel of the server's drive bay.
1. Use a regular Phillips screwdriver to attach the appropriate rails. Use the M3 screws provided
with the tape drive, as shown in Figure 4.
Ensure you do use the M3 screws provided. The rails may be attached to the filler panel by
screws of a different thread/size type and these should not be used. If in doubt, refer to your HP
ProLiant server documentation.
Figure 4 Attaching mounting rails
To Next Page
Loading...
