Need help?Do you have a question about the HP StorageWorks D2D - Backup Systems and is the answer not in the manual?
Defines the target users for this guide.
Lists other documents providing relevant information.
Explains text formatting and symbols used in the manual.
Provides information on how to get technical support.
Instructions for installing rack rails for system mounting.
Details on connecting power and network cables.
Outlines the software installation process.
Lists necessary hardware for connecting tape devices.
Lists compatible tape library and drive models.
Steps for manually installing system drivers.
Information on setting up the iSCSI initiator for host connection.
Explains different Fibre Channel connection types.
Discusses SAN zoning for optimal performance.
Describes status indicators on the front panel.
Describes status indicators on the rear panel.
Explains LEDs for Fibre Channel cards.
Introduces the concept of data synchronization between systems.
Discusses common replication setup models.
How to access and log into the interface.
How to configure devices via the interface.
Ways to archive data to offsite storage.
Explains Copy and Export methods for data archiving.
Lists prerequisites for copying data to host-attached tape.
Discusses data compression during tape operations.
Outlines different restore situations.
Steps to reconnect after host failure.
Steps to resolve network connection issues.
How to handle interface errors and warnings.
Troubleshooting device power issues.
Identifies signs of disk failure using LEDs and interface.
Step-by-step guide for replacing failed drives.
Steps and considerations for capacity upgrades.
Instructions for physical installation of the kit.
How to connect the kit to the main unit.
To Next Page
General