Using the Tape Attach web pages
The Tape Attach web pages allow you to configure attached tape storage device, run jobs manually,
create and run job schedules, view status and job history.
Configuration (Tape Attach)
This page allows you to view physical tape storage devices that are attached to the HP D2D Backup
System. The top half of the page shows a list of configured physical tape devices.
NOTE:
Up to four tape drives may be connected (including tape drives in libraries). Only one tape attach
operation (import, export or copy) may take place at any one time.
NOTE:
Standard HP Ultrium barcodes should be applied to all cartridges in libraries to ensure correct media
type identification.
Select a device to display its details in the lower half of the page. There are four tabs in the Details
section: Devices, Cartridges, Support and Firmware.
Using Tape Attach154
To Next Page
Loading...
Need help?
General