8 The Web Management Interface
In this chapter:
• “Web management interface” on page 107
• “To run the Web Management Interface” on page 107
• “Summary (Home)” on page 108
• “Devices (Configuration)” on page 110
• “Cartridges (Configuration)” on page 116
• “Network (Configuration)” on page 120
• “Email Alerts (Configuration)” on page 122
• “Storage (Status)” on page 124
• “iSCSI (Status)” on page 129
• “Log (Status)” on page 130
• “Status (Replication)” on page 131
• “Mapping Configuration (Replication)” on page 132
• “Appliance (Replication)” on page 135
• “Local Settings (Replication)” on page 137
• “Event History (Replication)” on page 138
• “Shutdown (Settings)” on page 141
• “Admin (Settings)” on page 139
• “Date and Time (Settings)” on page 140
• “Firmware (Settings)” on page 142
• “Support (Settings)” on page 144
What is the Web Management interface?
The Web Management Interface is the main interface for:
• Monitoring the status and health of the HP D2D Backup System and all configured backup devices
• Changing the number of cartridge slots or creating additional libraries, or standalone tape drives,
for a host
• Managing movement of data to and from a physical tape drive attached to the HP D2D (if one
has been installed)
• Creating and configuring Fibre Channel devices, if required
• Creating slot mappings and configuring replication, if required
To run the Web Management Interface
There are two ways of logging on:
• From the host server or PC: Use the desktop shortcut created by the Installation wizard.
D2D Backup System HP D2D4112 107
To Next Page