This is the status of the replication link between this pair of mapped
slots.
Replication Status
The replication wizards
When you select a Non-Replicating library, you will be able to run the Replication or Recovering
wizard.
• Use the Replication wizard to create slot mappings for the non-replicating library; it becomes a
Source library. See “The Replication process” on page 88 for more information.
• Use the Recovery wizard to recover cartridges from a Target Library. See
“Recovering a source appliance” on page 94 for more information.
Appliance (Replication)
This page shows you the replication status of the HP D2D Backup System and all Target HP D2D
Backup Systems that have been configured for use with it. You can also add Target HP D2Ds on this
page that the Source Appliance can use for replication. However, it is not necessary to do so before
mapping configurations because this option is also available when running the Replication wizard.
See “Status (Replication)” on page 131 for more information about the Status section at the top of this
page.
The Status Details section contains two tabs: one for Target Appliances and one for Source Appliances.
• The Source Appliances tab is not editable. If the HP D2D Backup System also has Replication-
Target libraries, there may be multiple Source Appliances.
• The Target Appliances tab allows you to add, edit and remove Target Appliance details.
D2D Backup System HP D2D4112 135
To Next Page
Loading...
Need help?
General