To edit the FC configuration
Click Edit to make the fields editable for each port. Make the required changes and click Update.
• Speed: The default is Auto, which is the recommended option. For users who wish to fix the speed,
other available values are 4Gbs (preferred), 2Gbs or1Gbs (not recommended).
• Topology: The default is Auto, which is the recommended option. Loop, where the HP D2D Backup
System simulates a large number of FC devices, and N_Port, when a single target device creates
many virtual devices on a fabric attach port, are also supported. N_Port requires the switch port
to support NPIV (N_Port ID Virtualisation).
Fibre Channel (Status)
This page shows the details for all the FC devices that are configured on the HP D2D Backup System.
Select a library in the Devices list to view the connection details for the library's media changer and
drive(s).
This page is mainly for information and is useful in troubleshooting. It cannot be edited.
HP D2D Backup Systems and Fibre Channel68
To Next Page
Loading...
Need help?
General