5. Run the Web Management Interface and create at least one library device. Be sure to select one
of the FC ports in the Port drop-down. For information about the other fields, see
“To create a new device” on page 113.
6. Configure zones on the FC Fabric/Switch.
7. The library device(s) should now be visible to the host. It may be necessary to perform a system
re-scan.
Fibre Channel (Configuration)
There is a page on the Web Management Interface that allows you to view and edit Fibre Channel
SAN settings, if necessary. It shows FC settings for each port on the FC card.
D2D Backup System HP D2D4112 67
To Next Page
Loading...
Need help?
General