What to do if HP StorageWorks P9000 - Disk Arrays Storage host detects a parity error?
If the host detects a parity error, check the FCA and make sure it was installed properly. Reboot the host.
How to get HP Storage logical devices recognized by the host?
If the logical devices are not recognized by the host, verify the following: * The READY indicator lights on the disk array are ON. * Fiber cables are correctly installed and firmly connected. * The TIDs/WWNs on each bus are unique. Do not install two devices with the same ID on the same bus. Recheck the buses for new devices. * The maximum number of LUSE devices per port has not been exceeded. * The disk array host mode is set correctly.
What to do if HP StorageWorks P9000 - Disk Arrays Storage file system is not mounted after rebooting?
If a file system is not mounted after rebooting, verify that the host was restarted correctly and that the file system attributes are correct.
How to fix HP StorageWorks P9000 - Disk Arrays Storage physical volumes that cannot be created?
If physical volumes cannot be created, verify that the disk array logical devices are correctly formatted.
Why can't I create logical volumes on my HP StorageWorks P9000 - Disk Arrays Storage?
If logical volumes cannot be created, verify that the volume capacity for OPEN-x volumes is not greater than the maximum capacity allowed. Verify that the capacity of the volume group is not less than the total capacity of the partitioned logical volume.
What to do if HP StorageWorks P9000 - Disk Arrays Storage disk array performs a self reboot?
If the disk array performs a self reboot because the disk array was busy or it logged a panic message, reboot the host.
Why are only Exit and Refresh menus effective when accessing the SVP from HP StorageWorks P9000 - Disk Arrays Storage Remote Web Console?
The SVP might not be ready, or another user is performing write processing. Wait and then refresh the window.
What to do if a Business Copy Z error message is displayed on HP StorageWorks P9000 - Disk Arrays Storage Remote Web Console?
Select the failed volume in the Preview List on the Pair Operation window, right-click to display the menu, and then click Error Detail.
What to do if Remote Web Console hangs, or Business Copy Z operations do not function properly on HP StorageWorks P9000 - Disk Arrays?
Ensure all Business Copy Z requirements and restrictions are met. Also, verify that the storage system is powered on and fully functional. Check all input values and parameters to ensure that you entered the correct information on the Business Copy Z windows, such as S-VOL and T-VOL IDs.
How to fix volume pairs that are not displaying correctly on HP Storage?
Make sure the correct volumes are selected.
General| Form Factor | Rack-mountable |
|---|---|
| Model | HP StorageWorks P9000 |
| Type | Disk Array |
| Category | Storage |
| Drive Type | SSD, SAS |
| RAID Levels | RAID 0, 1, 5, 6, 10 |
| Host Interface | Fibre Channel, FCoE, iSCSI |
| Connectivity | Fibre Channel, FCoE, iSCSI |
| Cache Memory | Up to 512 GB |
| Controllers | Dual controllers |
| Management Software | HP StorageWorks Command View |
| Redundancy | controllers, power supplies, and fans |
| Operating Humidity | 20 to 80% relative humidity, non-condensing |
To Next Page
