Diagnostics and troubleshooting62
B4 Loader to drive communication
IC error
Failure in IC handling loader to drive
communication. Contact your technical
support representative.
B5 Display error Cycle power on the autoloader and attempt
the operation again. If the error recurs, contact
your technical support representative.
B6 Memory error Cycle power on the autoloader and attempt
the operation again. If the error recurs, contact
your technical support representative.
B7 Timeout on autoloader
command
Cycle power on the autoloader and attempt
the operation again. If the error recurs, contact
your technical support representative.
B9 Database error Cycle power on the autoloader and attempt
the operation again. If the error recurs, contact
your technical support representative.
BA Load time-out Cycle power on the autoloader and attempt
the operation again. If the error recurs, contact
your technical support representative.
BB Unload time-out Cycle power on the autoloader and attempt
the operation again. If the error recurs, contact
your technical support representative.
BC VS80: Drive bug-checked Cycle power on the autoloader and attempt
the operation again. If the error recurs, contact
an HP support representative.
BC Ultrium/SDLT: Drive has
recorded an over-temperature
condition
Make sure that the unit is in an environment
with adequate ventilation and cooling, as
stated in ”Tape Drive Specifications” on
page 80, then check that both the internal fan
and the fan on the back of the unit are
working.
BD VS80: Autoloader has loaded a
cartridge but drive is empty
Cycle power on the autoloader and attempt
the operation again. If the error recurs, contact
your technical support representation.
Ultrium/SDLT: No connection to
drive
Table 18 Main Error codes
Error Code Description Details
To Next Page
Loading...
