HP StorageWorks XP20000/XP24000 - Disk Array - Page 186

Set Subsystem Time
Set Subsystem Time operation
TOD Change and Synchro. Infor
TOD Change is the selected parameter for example 1, and Synchro. Infor is the selected parameter
for example 2. This operation uses the following parameters, as shown in Table 153.
Table 153 Parameters for Set Subsystem Time Operation
DescriptionParameter
The date and the time.TOD Change
The setting of time correction function.Synchro. Infor.
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 154.
Table 154 Set Subsystem Time Operation
DescriptionItem
Indicates the date and the time in the format of YYYY/MM/DD HH:mm:SS .(YYYY: year,
MM: month, DD: date, HH: hour, mm: minute, SS. second).
Time
Indicates whether the time correction function is valid or invalid.
Valid: Enable, Invalid: Disable
Use Synchro.
The IP address (IPv4 or IPv6) of SNTP server.SNTP IP
The port used by SNTP server.SNTP Port
The time zone.Time Zone
The time when the time correction function is executed. Only HH (Hour: 00 to 23) is
indicated for the execution time.
Check Time
System Option Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Install],System Option,,Normal end,,,Seq.=xxxxx
+Spare Disk Recover=Full Speed
+Disk Copy Pace=Slower
+Copy Operation(Correction Copy)=OFF
+Copy Operation(Dynamic Sparing)=OFF
+Read Configuration Data Mode=OFF
+Power Lost Mode=Destage Mode
+Cache Segment Size(SideA,SideB)=64(64,64)
+Link Failure Threshold=10
+Power Supply Type=3-phase AC Box(40A)
Install Function186