2. Detach the RTC battery (2) from the battery. (The RTC battery is attached to the battery with double-
sided adhesive.) cad edit-visible line on bottom border
3. Remove the RTC battery and cable.
Reverse this procedure to install the RTC battery.
Battery
Description Spare part number
For use only on HP Stream 11 Pro G2 Notebook PC computer models 824536-850
For use only on HP Stream Notebook PC computer models 824560-005
Before removing the battery, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the keyboard/top cover (see Keyboard/top cover on page 30).
NOTE: When replacing the battery, be sure that the RTC battery (see RTC battery on page 38) is removed
from the defective battery and installed on the replacement battery.
Remove the battery:
1. Disconnect the battery cable (1) from the system board.
2. Release the speaker cables from the routing clips (2) built into the battery.
3. Disconnect the RTC battery cable (3) from the system board.
Component replacement procedures 39