HP Wireless Barcode Scanner User Manual

Figure 1-16 Exit Global Suffix Mode
Figure 1-17 Exit Programming Mode
Volume
Scan the following bar code to set the scanner back to the factory defaults.
Figure 1-18 Set All Defaults
Scan the following barcode to set the volume of the good read beep on the HP Wireless Barcode
Scanner:
Figure 1-19 Enter Programming Mode
Scan one of the four barcodes to set the volume to the desired setting:
Figure 1-20 Off
Figure 1-21 Low
4 Chapter 1 Quick Setup

HP Wireless Barcode Scanner Specifications

General

Brand	HP
Model	Wireless Barcode Scanner
Category	Barcode Reader
Language	English