EasyManua.ls Logo

HP XP P9500

HP XP P9500
95 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure 10 LUN configuration
RAID Manager uses absolute LUNs to scan a port, whereas the LUNs on a group are mapped for
the host system so that the target ID & LUN, that is indicated by the raidscan command, is different
from the target ID & LUN shown by the host system. In this case, the target ID & LUN indicated by
the raidscan command should be used.
In this case, you must start HORCM without a description for HORCM_DEV and HORCM_INST
because target ID & LUN are unknown. Use the port, target ID, and LUN displayed by the raidscan
-find or raidscan -find conf command for HORCM_DEV (see Example 8 “Displaying the port, TID,
and LUN using raidscan).
For details on LUN discovery based on a host group, see Host Group Control in the HP
StorageWorks P9000 RAID Manager User Guide.
Example 8 Displaying the port, TID, and LUN using raidscan
# ls /dev/rdsk/* | raidscan -find
DEVICE_FILE UID S/F PORT TARG LUN SERIAL LDEV PRODUCT_ID
/dev/rdsk/c0t0d4 0 S CL1-M 0 4 31168 216 OPEN-3-CVS-CM
/dev/rdsk/c0t0d1 0 S CL1-M 0 1 31168 117 OPEN-3-CVS
/dev/rdsk/c1t0d1 - - CL1-M - - 31170 121 OPEN-3-CVS
UID: displays the Unit ID for multiple RAID configuration. If UID appears as ‘-’ then the command
device for HORCM_CMD is not found.
S/F: displays that a PORT is SCSI or Fibre.
PORT: displays the RAID storage system port number.
TARG: displays the target ID (converted by the Fibre conversion table, see “Fibre address conversion
tables (page 53)).
LUN: displays the Logical Unit Number (converted by the Fibre conversion table).
SERIAL: displays the production number (serial#) of the RAID storage system.
LDEV: displays the LDEV# within the RAID storage system.
PRODUCT_ID: displays product-id field in the STD inquiry page.
Fibre address conversion tables
Table 15 (page 54), Table 16 (page 54), Table 17 (page 55) and show the Fibre address
conversion tables:
Table number 0 = HP-UX systems (see Table 15 (page 54))
Table number 1 = Solaris and IRIX systems (see Table 16 (page 54))
Table number 2 = Windows systems (see Table 17 (page 55))
Fibre address conversion tables 53

Table of Contents

Other manuals for HP XP P9500

Related product manuals