3. Align the connectors on the PCIe drive with the socket on the system board and install the drive into the
socket.
NOTE: The drive may be used only in PCIe slot 3, slot 4, or slot 5. Only use slot 3 if slot 4 and slot 5 are
occupied.
4. Connect the LED cable to the HDD activity header on the PCIe drive, which is marked HDDACT1. Then,
connect the other end of the LED cable to the HDD LED connector on the system board.
NOTE: To locate the HDD LED connector on the system board, see the System Board Overview on the
service panel.
5. Press the two green PCI retention clamp tabs on the rear of the chassis up until they lock into place.
10 HP Z Turbo Drive installation
To Next Page
Loading...
