Resetting the power supply
If an overload triggers the power supply overload protection, power is immediately disconnected.
To reset the power supply:
1. Disconnect the power cord from the workstation.
2. Determine what caused the overload, and x the problem. For troubleshooting information, see
Diagnostics and troubleshooting on page 46.
3. Reconnect the power cord, and restart the workstation.
When you turn o the workstation through the operating system, power consumption falls below what is
considered low power consumption but does not reach zero. Power consumption only reaches zero when you
unplug the workstation from the power outlet.
Component replacement guidelines 45
To Next Page
Loading...
