10. Insert the fan holder/card guide assembly. Make sure that the fan cable can reach the power
receptacle on the system board.
TIP: Rotate the fan assembly slightly from side to side to fit it into the chassis.
CAUTION: Clamping a cable between the card guide and the chassis might damage the cable.
Figure 5-35 Inserting the fan holder/card guide assembly
11. Finish installing the fan holder/card guide assembly, as shown in the following illustration:
a. Slide the fan holder/card guide toward the front of the chassis (1).
b. Rotate the fan holder/card guide so that the bottom tabs snap into the grid on the chassis
first, followed by the top tabs (2).
CAUTION: Clamping a cable between the card guide and the chassis might damage the
cable.
c. Plug the front fan connector into the front chassis fan header on the system board (3).
NOTE: To locate system board components, see the service label on the side access panel
108 Chapter 5 Replacing components ENWW
To Next Page
Loading...
