Working with non-hp papers –Version for firmware 3.x
3. Then Select “Add New Paper” and use the browser below to use your personal ICC
profile.
4. Create a name for your paper (which will be displayed both in the driver and in the
front panel) and to select a paper category that is similar to the type of paper you have.
8. The next step is selecting the appropriate media profile. Just select the same entry
as shown in “Front Panel & Driver selection” table on page 3. This is the most
important step, since you are in fact determining a number of basic parameters for
printer-paper interaction. Among others, these include: ink limiting, maximum density and
Hewlett-Packard
20
To Next Page
Loading...
