1. Identify the location of the memory module slots (1) – (4). The system memory must be installed in the
order shown. The BIOS checks for this and will not boot if the memory is not installed into the correct
slots. The BIOS will display a message in POST notifying the user that the system memory is not
installed in the proper order.
2. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module.
(The memory module tilts up.)
3. Remove the memory module (2) by pulling the module away from the slot at an angle.
Reverse this procedure to install a memory module.
Component replacement procedures 45
To Next Page
Loading...
