Speakers
Description Spare part number
Anti-magnetic speaker bracket (part of the bracket kit) 848360-001
Speakers (includes cable) 848361-001
Before removing the speakers, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see Service door on page 33).
5. Remove the battery (see Battery on page 34).
6. Remove the hard drives (see Hard drive on page 35).
7. Remove the SSDs (see Solid-state drives (M.2) on page 39).
8. Remove the middle frame (see Middle frame on page 48).
Remove the speakers:
1. Remove the Phillips screw (1) that secure the anti-magnetic speaker bracket to the computer.
2. Remove the bracket (2).
3. Remove the two Phillips screws (1) that secure the right speaker to the computer.
4. Remove the right speaker (2).
Component replacement procedures 49
To Next Page
Loading...
