EasyManuals Logo

HP ZR2440w User Manual

HP ZR2440w
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
3 Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, then follow the instructions below.
NOTE: Be sure the master power switch, located on the rear panel of the monitor, is in the off
position. The master power switch turns off all power to the monitor.
Installing the Pedestal
NOTE: Do not install the pedestal if the monitor will be used on a wall, swing arm, or other mounting
fixture; instead see
Mounting the Monitor to User-Supplied Support Hardware on page 15 in this
chapter.
CAUTION: Whenever you handle the monitor, take care not to touch the surface of the LCD panel.
Pressure on the panel may cause non-uniformity of color or disorientation of the liquid crystals. If this
occurs the screen will not recover to its normal condition.
To assemble the ZR2040w, slide the pedestal upright into its base, as shown below.
Figure 3-1 Assembling the ZR2040w pedestal
6 Chapter 3 Setting Up the Monitor ENWW

Table of Contents

Other manuals for HP ZR2440w

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ZR2440w and is the answer not in the manual?

HP ZR2440w Specifications

General IconGeneral
3DNo
Pixel pitch0.270 x 0.270 mm
Aspect ratio16:10
Response time6 ms
Display surfaceMatt
Display diagonal24 \
Display resolution1920 x 1200 pixels
Viewable size diagonal611.3 mm
Contrast ratio (dynamic)2000000:1
Contrast ratio (typical)1000:1
Display number of colors-
Digital vertical frequency24 - 60 Hz
Digital horizontal frequency24 - 80 kHz
Display brightness (typical)350 cd/m²
Supported graphics resolutions1920 x 1200 (WUXGA)
HDCPYes
USB hub version2.0
DVI-D ports quantity1
USB Type-A downstream ports quantity4
Ethernet LAN (RJ-45) ports0
Tilt angle range-5 - 35 °
Height adjustment100 mm
Panel mounting interface100 x 100 mm
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (standby)0.5 W
Power consumption (typical)48 W
Storage temperature (T-T)-20 - 60 °C
Operating temperature (T-T)5 - 35 °C
Operating relative humidity (H-H)20 - 80 %
Cables includedDisplayPort, DVI, USB
CertificationEPEAT Gold, CB, CE, FCC, ETLus, VCCI, C-tick, BSMI, TUV-S, ISO9241-307, TUV-GS, CCC, CECP, CEL, NOM, PSB, KC, GOST, ISC
Country of originChina
Compliance industry standardsTCO 5.0
Sustainability certificatesENERGY STAR
Weight and Dimensions IconWeight and Dimensions
Depth (without stand)61 mm
Width (without stand)562 mm
Height (without stand)368 mm
Weight (without stand)7600 g

Related product manuals