Screen Messages
Models that use an OSD also use screen messages to keep you informed:
●
Monitor Status When the monitor is powered on and when the input source is changed, a
Monitor Status message is displayed for five seconds. The message shows which input is currently
active, the status of the auto-switch source setting (On or Off), and the default source. If the current
mode is a preset, the message gives the current resolution and refresh rate; if not, it gives the
horizontal and vertical frequencies and recommended resolution. Blocks of red, green and blue
verify that the three colors are working.
●
Scanning Inputs Indicates the monitor is searching for an active input.
●
Input Signal Out of Range — Change resolution setting to... Indicates the monitor does
not support the input signal because the resolution and/or refresh rate are set higher than the
monitor supports.
●
No Source Signal, No Input Signal When no input is active, the monitor will go into low
power mode. But if low-power mode is disabled, the monitor displays the “No source signal” or
“No input signal” message.
●
Auto Adjustment in Progress Indicates the auto-adjustment function is active.
●
Monitor Going to Sleep Indicates the screen display is entering low power mode.
●
Check Video Cable Displayed when there are no video cables connected or when you try to
select an input that is not properly connected.
●
OSD Lockout The OSD can be enabled or disabled by pressing and holding the Menu button
on the front panel for 10 seconds. If the OSD is locked when you press the Menu button, the
warning message OSD Lockout displays for ten seconds.
◦
If the OSD is locked, press and hold the Menu button for 10 seconds to unlock the OSD.
◦
If the OSD is unlocked, press and hold the Menu button for 10 seconds to lock the OSD.
●
Power Button Lockout Indicates the power button on the front of the monitor is locked.
◦
If the power button is locked, press and hold it for 10 seconds to unlock it.
◦
If the power button is unlocked, press and hold it for 10 seconds to lock it.
●
Dynamic Contrast Ratio On Indicates that Dynamic Contrast Ratio has been turned on. This
occurs if Dynamic Contrast Ratio is turned on in the Image Control OSD menu.
●
Dynamic Contrast Ratio Off Indicates that Dynamic Contrast Ratio has been turned off. This
occurs if Dynamic Contrast Ratio is turned off in the Image Control OSD menu.
●
Theft Mode Enabled Indicates that theft deterrence mode has been activated. Theft deterrence
is an optional feature that can be set up in HP Display Assistant. Theft deterrence mode is
triggered if both the power and display cables have been disconnected from the monitor, the
monitor is reconnected to a different computer, and the theft deterrence PIN number is not entered
within the elapsed time. When the monitor is in theft deterrence mode, all front panel buttons are
disabled other than the power button.
ENWW
Overview of Operation
35
To Next Page
Loading...
Need help?
General
Weight and Dimensions
