HPE ProLiant MicroServer Gen8 User Manual

QuickSpecs
HPE ProLiant MicroServer Generation 8 (Gen8)
Standard Features
Page 3
HPE
ROM provides for essential initialization and validation of hardware components before control is
passed to the customer
-installed operating system. The ROM also provides the capability of booting
from various fixed media (HDD, CD
-ROM) and removable media (USB), to continue operation to the
operating system.
HPE
ROM performs very early configuration of the video controller, to allow monitoring of initialization
progress via an attached monitor. If configuration or hardware errors are
discovered during this early
phase of hardware initialization, suitable messages are now displayed on the connected monitor.
Additionally, these configuration or hardware errors are logged to the Integrated Management Log
(IML) to assist in diagnosis.
The
Hewlett Packard Enterprise ProLiant ROM is used to configure the following:
Processor and chipset status registers
System memory, memory map, and memory initialization
System hardware configuration (Integrated PCI devices and optional PCIe cards).
Custome
r-specific BIOS configuration (using the HPE ROM-Based Setup Utility (RBSU).
NOTE:
For further information, please refer to The Hewlett Packard Enterprise
RBSU (ROM based
setup utility) user guide: http://www.hp.com/support/rbsu.
Storage Controller
HPE Dynamic Smart Array B120i Controller
NOTE: HDD bays 1 and 2 support 6.0Gb/s SATA. HDD bays 3 and 4 support 3.0Gb/s SATA.
NOTE: Supports RAID 0/1/10 only. No FBWC support. For FBWC, a standup Smart Array
Controller card must be configured.
NOTE: For more information about the controller and its features, see the HPE Dynamic Smart
Array RAID Controller User Guide on the HPE website:
(http://www.hp.com/support/DSA_RAID_UG_en
).
NOTE: To configure arrays, see the Configuring Arrays on HPE
Smart Array Controllers Reference
Guide on the HPE website (http://www.hp.com/support/CASAC_RG_en).
NOTE: For general information about HPE Smart Array B120i SATA RAID Controller, please go to:
http://h18004.www1.hp.com/products/servers/proliantstorage/
arraycontrollers/dynamicsmartarray/index.html
Internal Storage Devices
Optical Drive
Optional: SATA DVD-RW drive
Hard Drives
None ship standard
Maximum Internal
Storage
Non-Hot Plug SATA 16TB (4 x 4TB) 3.5" SATA
Interfaces
Video
1 Rear standard video
HPE
iLO Remote
Management Network
Port
1Gb Dedicated (default iLO4 configuration)
Micro SD slot
1 Internal
NOTE: The MicroSD slot is not a hot-pluggable device. Customers
should not attempt to plug a MicroSD card into the MicroSD slot while
the server is powered.
USB 2.0 Ports
5 total (2 front, 2 rear, 1 internal)

HPE ProLiant MicroServer Gen8 Specifications

General

Brand	HPE
Model	ProLiant MicroServer Gen8
Category	Server
Language	English