HPE ProLiant ML110 Gen9 User Manual

HPE ProLiant ML110 Gen9 Server
Maintenance and Service Guide
Abstract
This guide describes identification and maintenance procedures, diagnostic tools, specifications and requirements for hardware
components and software. This guide is for an experienced service technician. Hewlett Packard Enterprise assumes that you are
qualified in the servicing of computer equipment, trained in recognizing hazards in products, and are familiar with weight and stability
precautions.
Part Number: 790389-006
Au
gust 2017
Edition: 6

HPE ProLiant ML110 Gen9 Specifications

General

Product Type	Server
Form Factor	Tower
Processor Sockets	1
Memory Type	DDR4
RAID Support	RAID 0, 1, 5, 10
Processor	Intel Pentium, Celeron, Core i3
Memory Slots	8
Storage	SATA, SAS
Storage Controller	Dynamic Smart Array B140i
Network	Gigabit Ethernet

Summary

Removal and Replacement Procedures

Safety and Preparation

Covers essential safety guidelines, warnings, and setup steps before component replacement.

Drive Components

Procedures for removing drive cages, blanks, and hot-plug/non-hot-plug drives.

Core Internal Components

Guides for replacing fans, heatsinks, processors, DIMMs, and system boards.

Power and Related Components

Procedures for replacing power supplies, batteries, iLO modules, and TPMs.

Expansion Components

Instructions for replacing M.2 SSDs, GPUs, and FBWC modules.

Diagnostic Tools

Server Management Tools

Details HPE iLO, Active Health System, and Pre-boot Health Summary.

System Utilities and Diagnostics

Component Identification

Front Panel Components and Indicators

Rear Panel Components and LEDs

System Board Components

System Switches and Functionality

Cabling

Storage Cabling

Internal Component Cabling

Power Supply and Front Panel Cabling

Specifications

Environmental Specifications

Server and Power Supply Specifications