• Server in rack mode: Remove the server from the rack on page 23.
• Server in tower mode: Position the tower server for hardware configuration on page 25.
5. Remove the access panel on page 25.
6. Remove the PCI air baffle on page 29.
7. Remove the system air baffle on page 30.
8. Disconnect all the power supply cables connected to the system board.
9. Remove the existing power supply.
10. Install the ATX 550W non-hot-plug power supply.
11. Connect the power supply cables.
12. Install the system air baffle on page 31.
13. Install the PCI air baffle on page 30.
58 Hardware options installation
To Next Page
Loading...
