10. Connect the cable to the rear of the drive and then route the cable through the drive bay.
11. Connect the optical drive SATA and power cable to the system board and power supply.
12. Install the system air baffle on page 31.
13. Install the PCI air baffle on page 30.
14. Install the access panel on page 26.
15. Do one of the following:
• Server in rack mode: Install the server into the rack on page 53.
• Server in tower mode: Return the server to an upright position.
16. Connect all peripheral cables to the server.
17. Connect each power cord to the server.
70 Hardware options installation
To Next Page
Loading...
