IMPORTANT: Do not exert force once you
encounter resistance. Doing so can damage the
module.
2. When the magazine is released, pull it straight out of
the module while supporting it from the bottom.
3. Repeat the process for the other magazine in the
module.
Preparing to remove the robotic assembly
and spooling mechanism
Procedure
1. Using a #2 Phillips screwdriver, loosen the front
captive fasteners that secure the base module to the
rack two full turns.
2. If there are adjacent expansion modules:
a. Loosen the front captive fasteners two full turns on
the adjacent expansion modules.
b. On the back of the base module and the module
above (if present), move the alignment
mechanisms into the unlocked position.
c. Disconnect and completely remove the expansion
interconnect cables from the base module and
from the adjacent modules.
Removing the expansion interconnect cables
prevent damaging the cables when moving the
module in and out of the rack.
3. Disconnect the AC power cables from the base
module.
4. Disconnect the Ethernet, SAS, and Fibre Channel
cables from the base module.
5. Remove any USB devices, if present.
6. Completely loosen the front captive fasteners of the
base module.
7. With assistance and while supporting the bottom of
the module in the areas supported by the rack
shelves, slide the module out of the rack and set it on
a flat, sturdy, static-safe work surface.
IMPORTANT: To avoid personal injury or
damage to the module, always support the
bottom of the module where the rack shelf
contacts the module. Do not touch internal
mechanical or electrical components while
moving the module.
8. Remove the library top cover plate, if present:
a. Unlock the top cover using two small screwdrivers.
b. Lift the cover front end by about 12 cm.
c. Gently pull the cover forward to disengage from
the pivot point at the module center.
Page 3
To Next Page
Loading...
