HPRT HM-T300 - Page 19

HM-T300 User Manual
13
Example
When you want to change the settings of the printer mode as shown below,
Item
Factory Setting
Configuration Example
1 Density
0(Medium)
1(Low)
2 Standby Time
0060(Sec)
0080(Sec)
3 Auto Off Time
0120(Min)
1120(Min)
4 Paper Type
4(Label)
1(BM(3inch))
5 Set Language
0(EN)
0(EN)
6 Factory Reset
0(Cancel)
0(Cancel)
Press and hold the MODE & FEED buttons for 5 seconds.
→
You will see present “Enter Menu Mode” in the LCD.
Press the MODE button once to switch the menu item.
Display: 1 Self Test →2 System Setting
→
Press the FEED button to get into the menu.
Display:
1 Density
2 Standby Time
3 Auto Off Time
4 Paper Type
5 Set Language
6 Factory Reset
7 Previous Menu
 You can press MODE button to switch the menu item, press the FEED button once to enter the menu.
→Press the FEED button once to get into the Density menu.
Display:
Density:
0-Medium 1-Low
2-High 0
3-Special
→
Press the MODE button once to input the number 1, then press and hold FEED button to confirm the new
setting and return to the previous menu.
0(Medium) → 1(Low)