HPRT HM-T300 - Page 21

HM-T300 User Manual
15
new setting and return to the previous menu.
(The paper type has set to BM(3inch))
4(Label) →1(BM(3inch))
 Press the MODE button 4 times to switch the menu item--Set Language.
→Press the FEED button once to get into the menu.
Display:
Language
0-EN 1-CH
0
 Press the MODE button 5 times to switch the menu item--Factory Reset.
→Press the FEED button once to get into the menu.
Display:
0-Cancel
1-Factory Reset
0
→
When the setting does not need to be reset, press and hold FEED button to return to the previous menu.
 Press the MODE button 6 times to switch the menu item--Previous Menu.
→Press the FEED button once to return to the previous menu.
Display:
1 Self Test
2 System Setting
3 Exit Menu
 Press the FEED button once to enter the menu item--Self Test
Display:
1 Print
2 Calibrate
3 Hex Dump Mode
4 Previous Menu
→
Press the FEED button once, you will see present “Press Feed To Print” in the LCD, press FEED button, the
new settings will be printed.
If the settings were not configured correctly, follow the above procedure to configure the settings again.