To Next Page

To Previous Page

HT100/HT130 User Manual

Rev.1.2

3.6 Basic Function

3.6.1 Power On/ Power Off

Press “O” to power off the printer. Press “l”to power on the printer.

3.6.2 FEED Button

1.Turn on the printer. Press the feed button, and printer will automatically feed a label under

“Label Mode”. Press the feed button, and the printer will feed the fixed distance under

“Continuous Mode”.

2.When the printer is printing, press the feed button so that the printing job pauses. At that

time the LED indicator is white. When press this button again, the printing job continues.

3.6.3 Quick Calibration

Note: Users must carry out the calibration under the conditions below:

 The first time to use the printer since installation;

 The first time to use the printer since sensor cleaning;



Reuse the printer when it has not been used for a long time;



Change a new type of media;



Printer cannot recognize the mark;



Huge change of the operating environment;

Calibration method:

1.Carry out the calibration manually.

When printer is ready, press the FEED button for 3 seconds until the status indicator(Blue)

flashes twice. Then release the button, and printer will start to do the calibration. When printer

does the calibration under Continuous Media Mode, the calibration is invalid.

2.Carry out calibration by printer utility tool. Please refer to detailed information in “Chapter 6

Label Printer Utility Instructions”.

Note: After the quick calibration, users could open the printer cover to pull back the

learned paper in avoid of paper wasting.

HPRT HT130 User Manual

Other manuals for HPRT HT130