EasyManua.ls Logo

HSD ES919 - User Manual

Default Icon
181 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Instructions for use
HSD
MECHATRONIC
DIVISION
5801H0056
EN
Rev.02
5801H0056 Rev.02 __________________________________________________________ 1/181
ES884 – ES888
ES915
ES919 – ES929 – ES939
ES983 – ES988

Table of Contents

Questions and Answers

  • V
    Valerie HartAug 6, 2025
    Why is my HSD ES919 electrospindle not rotating?
    • R
      Rachel TurnerAug 6, 2025
      The electrospindle might not be rotating due to several reasons: There could be no power supply, so check the mains voltage, connectors, and the integrity of electrical connections. Ensure a tool-holder is properly inserted. The thermal protective device might have tripped; if so, wait for the electrospindle to cool down. Lastly, the sensor S1(ISO30) or the series of sensors (HSK) might be disconnected or faulty, so check their connectors and electrical connections; adjust or replace the faulty sensor if needed.
  • M
    Matthew ScottAug 20, 2025
    What to do if the tool-holder is not locked in my HSD ES919 Tools?
    • S
      Sharon WileyAug 20, 2025
      If the tool-holder isn't locking, there might be a foreign body between the tool-holder and spindle shaft; remove any foreign matter and clean the area. Ensure the tool-holder cone is the correct type. Also, the collet may not be opening due to lack of pressure; check the required pressure values and the integrity of the pneumatic circuit. Lastly, sensor S2 could be disconnected or faulty; check the connectors and electrical connections, and adjust or replace the sensor if necessary.

Summary

Technical Specifications

Technical Cards ES884

Provides detailed technical data and performance specifications for ES884.

Technical Cards ES929

Provides a breakdown of technical parameters for ES929.

Use and Adjustment

Tool

Discusses tool selection, balancing, and speed limits for safe operation.

What to Do If the Tool Is Blocked on the Piece Being Worked

Outlines procedures for handling a blocked tool safely.

Sensors

Troubleshooting

The Electrospindle Does Not Rotate

Identifies causes and solutions for the electrospindle failing to rotate.

The Electrospindle Overheats

Discusses reasons and solutions for electrospindle overheating.

HSD ES919 Specifications

General IconGeneral
BrandHSD
ModelES919
CategoryTools
LanguageEnglish

Related product manuals