HTC 80 iD - The Dust Extractors Operating Position; Lower the Dust Extractor to the Service Position

HTC 80 iD Usage
1.1 15
4.2.1 The dust extractor's operating position
When the dust extractor is in use, it must be in the operating position, see Figure4-1,
page15.
Figure 4-1. Operating position
4.2.2 Lower the dust extractor to the service position
The dust extractor can be lowered to the service position by releasing the upper cylinder
section from the lower cylinder section, see Figure4-2, page16.
Start with the dust extractor in the operating position, see Figure4-1, page15. Then
follow the instruction below: