Huawei AR1200-S - Configuration Examples

Start time : 2012-03-14 00:00
End time : 2012-08-08 23:59
Status : Active
DEFAULT SEND KEY ID INFORMATION
Default : Not configured
13.5 Configuration Examples
This section provides configuration examples of the keychain module.
13.5.1 Example for Configuring Keychain Authentication for Non-
TCP Application
Networking Requirements
As shown in Figure 13-1, it is required to enable RIP and keychain authentication on all
interfaces of Router A and Router B. The Router s interconnect with each other using RIP-2.
Figure 13-1 Networking diagram of keychain
GE0/0/1
192.168.1.1/24
GE0/0/1
192.168.1.2/24
RouterA
RouterB
Configuration Roadmap
The configuration roadmap is as follows:
1. Configure keychain basic functions.
2. Configure the application RIP on both the Routers to use keychain.
Data Preparation
To complete the configuration, you need the following data:
l keychain name
l key-id
l algorithm and key-string
l send and receive time
l receive tolerance
Procedure
Step 1 # Configure RouterA
Configuring Keychain Authentication
<RouterA> system-view
Huawei AR1200-S Series Enterprise Routers
Configuration Guide - Security 13 Keychain Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
277