Huawei AR1200-S - Creating an Interzone; Enabling Firewall in the Interzone

The interface view is displayed.
Step 3 Run:
zone zone-name
The interface is added to the zone.
----End
3.3.4 Creating an Interzone
Create the interzone so you can enable the firewall to filter packets or application-layer services
in the specified interzone.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
firewall interzone zone-name1 zone-name2
An interzone is created.
The zones specified for an interzone must have been created on the device.
----End
3.3.5 Enabling Firewall in the Interzone
The configured firewall functions take effect only after you enable firewall in the interzone.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
firewall interzone zone-name1 zone-name2
The interzone view is displayed.
The zones zone-name1 and zone-name2 have been created through the firewall zone command.
Step 3 Run:
firewall enable
The firewall is enabled.
By default, the firewall function is disabled in an interzone.
----End
Huawei AR1200-S Series Enterprise Routers
Configuration Guide - Security 3 Firewall Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
52