Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4.2 NAT /Routing Behind MS Settings
Prerequisites
Install Service engine and LTE CPE and commission them so that they are ready to be
connected.
Configure the NAT Settings on Service engine.
Background Information
NAT and Routing Behind MS are mutually exclusive features. On the LTE CPE's web
interface, select NAT Enable under NAT Settings and click Apply to enable NAT Enable or
deselect NAT Enable under NAT Settings, and then click Apply to enable Routing Behind
MS.
Procedure
Step 1 Log in to the WebUI.
For details, see section 4.1 "Log in to the WebUI."
Step 2 Choose Settings > Security > NAT Settings. Deselect NAT Enable under NAT Settings and
click Apply to enable Routing Behind MS.
Figure 4-1 Enabling NAT
----End
4.3 Profile Management
Step 1 Log in to the WebUI.
For details, see section 4.1 "Log in to the WebUI."
To Next Page
Loading...
