HUA WEI
25
10 SMS
Sending and Receiving a Message
Writing a New Message
Click or select Tools > SMS, Then the SMS interface is displayed.
Step Action
1 Click Write and the Write interface is displayed.
2 Enter the telephone number(s).
You can enter one or more number(s) by one of the following ways:
y To enter one or more numbers directly: In the Contacts textbox, enter the
numbers separated by semicolons ";".
y To select a number from the contacts: Click Contacts. Select one or more
contact(s) and click OK. Select the number to send a message in the pop-up
dialog box and click OK.
Note:
y You can directly enter the numbers or select the numbers in the
contacts.
y When you select more than one contact, you can press Shift to
select a sequence of contacts, or press Ctrl to select the contacts
one by one.
y If you select several receivers, click the Apply to all items check
box to simplify the following operations.
3 Input the message, the character number is displayed in real time on the upper
right of the Contacts text box. The maximum length of each message is 1000
characters.
To Next Page
Loading...
