Huawei FusionServer Pro 2288H V5 - Page 29

Port Type Quantity Description
Management
network port
1000BASE-T 1 Used for server management.
NOTE
The management network port is
a GE port that supports 100
Mbit/s and 1000 Mbit/s auto-
negotiation.
USB port USB 3.0 2 Used to connect to a USB
device.
NOTICE
Before connecting an external
USB device, check that the USB
device functions properly. The
server may operate abnormally if
an abnormal USB device is
connected.
PSU socket - 2 Used to connect to the power
distribution unit (PDU) in the
cabinet. You can select the
number of power supply units
(PSUs) as required.
NOTE
● When determining the
quantity of PSUs, ensure that
the rated power of the PSUs
is greater than that of the
server.
● If only one PSU is used,
Predicted PSU Status cannot
be set to Active/Standby on
the iBMC WebUI.
Table 5-5 LOM port description
Chip Model
Port Type Rate
Negotiation
Mode
Supported
Rate
Rates Not
Supported
X722 10GE optical
port
Auto-
negotiation
10000 Mbit/s
(full duplex)
10000M 10/100/1000
M
10GE
electrical port
Auto-
negotiation
1000 Mbit/s
(full duplex)
1000M 10/100M
Huawei FusionServer Pro 2288H V5 Server
Technical White Paper 5 Hardware Description
Issue 12 (2020-04-20) Copyright © Huawei Technologies Co., Ltd. 23