6
Lowering a Fan (Applicable to Downflow Units)
3.5
1.Remove the six screws and then the beam. 2.Rotate the fan upward by 30 degrees, and
pull the rotating shaft of the fan to the
outermost side.
4.After the fan rotates to the position shown in the
figure, push the fan back to the horizontal position.
5.Use a torque wrench to secure the two beams,
and interconnect the fan cables using the
interconnection terminal reserved in the cabinet.
3.Slowly rotate the fan by 90 degrees and ensure that
the rotating shaft of the fan is on the outermost side.
Exercise caution when handling the fan to avoid body
injury.
4
Installing the Outdoor Unit
•
Protective cardboard for fins must be removed after installation to protect people from
injuries.
•
The installation methods and distance requirements of installing NetCol500-A060,
NetCol500-A080 and NetCol500-A120 outdoor units are the same. This section describes
how to install a NetCol500-A060. The NetCol500-A110 outdoor unit does not support
vertical installation.
• If the space does not meet the requirements of the recommended layout, you can use
any of the layouts (applicable only to NetCol500-A060) in user manual.
To Next Page
Loading...
