15 Connectivity status indicator 16 Full-height PCIe slot
NOTE
This slot is reserved and does not install PCIe
here.
17 Half-height PCIe slot - -
NOTE
The default IP address of the management network port (Mgmt) on the quorum server is
192.168.128.200, and the default subnet mask is 255.255.255.0.
Table 4-34 describes the indicators on the quorum server rear panel.
Table 4-34 Indicators on the rear panel
Num
ber
Indicator Color State
14 Data transmission status
indicator
Yellow
l Off: No data is being transmitted.
l Blinking: Data is being transmitted.
15 Connectivity status
indicator
Green
l Steady green: The network is
properly connected.
l Off: The network is not connected.
6 UID indicator Blue The UID button/indicator helps identify
and locate a quorum server in a rack.
You can turn on or off the UID indicator
by manually pressing the UID button or
remotely running a command on the
CLI.
l Steady on: The quorum server is
located.
l Off: The quorum server is not
located.
l You can hold down the UID button
for 4 to 6 seconds to reset the
system.
2 Power module indicator Green
l Steady green: The power input is
normal.
l Off: There is no AC power input, or
the power module is in the standby
state or is faulty.
OceanStor 2600 V3
Product Description
4 Hardware Architecture
Issue 09 (2019-05-15) Copyright © Huawei Technologies Co., Ltd. 97
To Next Page
Loading...
